3 Piece Two-Jaw Puller Set

Comments about Pittsburgh 3 Piece Two-Jaw Puller Set:

I have used the smallest one around 20x no problem, but never put too hard a pull on it

Comments about Pittsburgh 3 Piece Two-Jaw Puller Set:

I am usually as happy as i can expect from H.F. tools but the puller was a dissapointment and cost me time and money. As soon as I put tension on it the straps broke into pieces. This would be a great set if the parts were tempered or heat treated properly. Buy a more reputable brand because if you're gonna need a puller you're gonna need it to be strong.

Comments about Pittsburgh 3 Piece Two-Jaw Puller Set:

Used the 3 inch puller to remove a bearing from a small motor shaft (6201ZZ bearing) - The end of the screw is larger than the bearing bore and could not pull the bearing all the way off the shaft. Used it another time on another bearing and one arm broke off. I think I should have been better off buying a puller from another supplier.

Comments about Pittsburgh 3 Piece Two-Jaw Puller Set:

junk becareful

Comments about Pittsburgh 3 Piece Two-Jaw Puller Set:

I was putting in a new pinion seal and had to use this to pull the yoke off. put were little presure on it and it broke and nocked my hat off. Had to use my dads proto to finish. spend more money and get one at [@].

Comments about Pittsburgh 3 Piece Two-Jaw Puller Set:

I'm still trying to figure out what indoor and outdoor pulling is. Guess you can use these either place.