Universal Bench Grinder Stand

Comments about Universal Bench Grinder Stand:

I bought this for a reloading stand so my press doesn't take up any more bench space. Now when I am not reloading I can move it out of the way. Works great. Nice shelf on the bottom for bullets, powder, dies, etc, and can sit down and reload shells. Very happy with this stand for my purpose.
It is rather short, so if you plan on using this as it is intended, you will probobaly be bending over quite a bit.

Comments about Universal Bench Grinder Stand:

Goes together with a little persuasion. Not the best assembly, but with some patience and brains, it comes out good. Works fine for my 6" grinser, but plenty of other uses. Price with 20% off, can't be beat. Similar ones on E--- go for much more plus shipping!

Comments about Universal Bench Grinder Stand:

I bought this to set for my HB chainsaw sharpener. I hold in place with a HG 6" bar clamp so I can use for multiple uses. For such a small stand, it is very stable. There is no wobble! I am going to buy two more.

Comments about Universal Bench Grinder Stand:

Easy to assemble. Use a 10mm deep socket, not a wrench. Just be sure to read the instructions completely, as of course I didn't, because the lower bolts that join the legs hold the tool tray and you need to leave those out. Don't forget to get a coulple of lag bolts for your tool, as it doesn't come with them. I am using it for the HF 8" grinder. Works great and keeps me from having to mount it on my small workbench. Very solid, doesn't tip or walk. Very happy with it.

Comments about Universal Bench Grinder Stand:

This stand works great for my 6 inch buffer. It is sturdy and great priced. It took me about 30 to 40 minutes to put together but all in all it works great.

Comments about Universal Bench Grinder Stand:

I use this for a buffing machine, stand is very rigid however you may need to loc-tite the bolts so they don't vibrate loose. Assembly time was a bit longer than expected, but It worked great. I would buy this product again.

Comments about Universal Bench Grinder Stand:

used one a while back for pipe vise stand.
worked great.

Comments about Universal Bench Grinder Stand:

Well built only thing a little trouble with was the holes lining up. But with a little from a mallet it fit just fine.

Comments about Universal Bench Grinder Stand:

I needed a stand for my name brand mini lathe and the 20" Bed Extension, so I purchased two of these stands, made the top table out of a 2x12's and reinforced it with 2x4's. It only cost me $75 to make and I saved over $250 by not buying the name brand stand. I even have two 12" x 13" tool trays to put my turning tools and pen making supplies on.

Comments about Universal Bench Grinder Stand:

I bought this stand last week and put it together this past weekend. I don't know what some others are talking about it being hard to put together, because it only took me about 20 minutes and every part fit like a glove. My Delta grinder was too big for the pre-drilled holes, so I decided to mount it diagonally and had no problems drilling the new holes. The stand is sturdy, I used the grinder extensively on Saturday, cleaning up the jugs for my bike build project using a mounted wire-wheel...no problems at all. Some guys may really have had trouble with it but I had no problems at all...the stand is well worth the price!